Flic hub home assistant8/23/2023 If Apples homekit view in the phone hangs and it, from its point of view therefore fails to pair, the flic hub will then not be registered as. I've also removed the Flic app from all devices, and reinstalled it. If there is no pop-up in the flic app when you slide 'add to homekit' to on, it means the homekit pairing protocol has been successful, from the flic hubs point of view. You should find a line saying 'Found new button' 06:28:01 INFO (Thread-2) Found new button 80:e4:da:XX:XX:XX The name of the button is flicmacaddress without column. I have an iPad and Apple TV (also latest TvOS) configured as Home hubs. If youre using home assistant, check your Home Assistant log to find the name of your new button. I have the latest iOS (15.x) installed on both iPhone and iPad. I've also tried to add a new home in the Apple Home app. There is no mention of Apple Home in the Flic app settings either. The firmware upgrade is successful (3.0.12), but when I try to "Add to homekit" from the button configuration, the hub (and button) is not seen by HomeKit/Apple Home, and I never get any notifications regarding the Flic Hub requiring access to Homekit or network (that only happened once, the first time I went through this setup). : Flic Hub Luxury Stores 1-48 of 104 results for 'flic hub' RESULTS Flic 2 Smart button - Trigger Alexa & Apple HomeKit - Starter kit 3 x Flic 2 buttons + 1 x Flic Hub LR - Smart Home Control - Works with Hue, LIFX, IFTTT, IKEA Trdri, Sonos, Spotify and much more 4. Then I add a Flic 2 button and receive a message saying the hub's firmware needs to be upgraded, which I do. Both are connected to my router via Ethernet. In the home app the action flashed when the flic button was pressed so it seemed like physical comms were ok.Only thing is the target of the action (turn a light on) did not happen. Directly underneath my RPi4 is my Flic Hub LR. After upgrading to iOS 16 (on phone, homepods and atvs) and performing the underlying architecture upgrade my flic buttons stopped working. I have reset the hub at least 50 times (pin hole button, 13-15 seconds) and the hub is resetting OK. Flic Hub home assistant 7 7 440 Log in to reply stevehooper, 10:03 I have Home Assistant running on my Raspberry Pi 4B as the OS (not docker). After I purchased a dongle setup the flic integration and added this to my configuration.yaml. ![]() I have tried to re-add my Flic LR hub (and Flic 2) since october without any luck. The way I have mine setup is in 2 ways where natively the flic button talks with smartthings through the flic hub > smartthings > home assistant as a virtual switch.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |